Home › Service areas › Richmond, TX
Water softener & filtration installation in Richmond, TX
Richmond consistently tests at the high end of anything we measure in the metro. At these levels a standard 40-gallon water heater can lose meaningful capacity to scale inside a few years, and homeowners usually blame the heater instead of the water feeding it.
typical hardness
Reported range 12–18 gpg · scale 0–20
- Supplier
- Fort Bend County MUDs under the North Fort Bend Water Authority
- Source
- Groundwater blended with treated surface water
- Disinfectant
- Chloramine on most blended supplies
- Typical range
- 12–18 gpg
- Classification
- Very hard
Figures reflect typical published and field-observed ranges for supplies in this area. Your tap is what matters — we measure it free.
$3,500 Installed
Published price. Not a promo, not only good today.
Installation Included
No separate install fee. No maintenance contract.
Lifetime Warranty
Tanks, valves, housings and major components.
TCEQ-Licensed
Installed by licensed hands, as Texas requires.
The local picture
What Richmond homeowners actually call us about.
The complaint we hear most often in Richmond: Hot water running out faster than it used to in a heater that is not that old.
At 12–18 grains per gallon, every load of laundry, every shower and every cycle through the water heater carries dissolved calcium and magnesium that has to go somewhere. It goes onto your fixtures, into your heat exchanger, and onto your skin.
The supply here is groundwater blended with treated surface water, delivered through fort bend county muds under the north fort bend water authority, with chloramine on most blended supplies as the residual disinfectant. That combination determines both how we size the softener and how much carbon the system needs.
- Free in-home test at your kitchen tap — about 20 minutes
- System sized to your measured hardness, not a neighborhood average
- Installed by a TCEQ-licensed specialist or licensed plumber
- Flat price in writing, good for 30 days — no same-day pressure
Neighborhoods we serve in Richmond
Aliana, Harvest Green, Long Meadow Farms, Pecan Grove, Waterside Estates, Grand Mission — plus surrounding Fort Bend County communities.
Not listed? We cover the whole Richmond area and travel up to two hours from our Katy shop. Call (435) 881-7380.
What we usually recommend in Richmond
Richmond is at the hard end of everything we measure.
At 12–18 grains per gallon, Richmond tests higher than most of the Houston metro. That changes the sizing conversation: the system has to regenerate more often, so resin volume and valve type matter more here than almost anywhere else we work.
The Complete Home System at $3,500 is still the right starting point for most homes, with 75 lbs of resin and 48,000 grain capacity. For larger households at this hardness, the dual-tank build at $4,000 is worth the conversation — a full resin bed plus a full carbon bed rather than the two sharing one tank.
Because Richmond draws on groundwater, we also look at whether you need a pre-sediment stage. If you have seen grit in an aerator or your pressure drops after main work in the neighborhood, that is the tell. It is a cheap add-on that protects an expensive system.
Recent work
Systems available in Richmond: Complete Home System, Dual-Tank System, reverse osmosis, pre-sediment and a free water test.
FAQs
Richmond water questions.
How hard is the water in Richmond, TX?
Supplies serving Richmond typically test in the 12–18 grains-per-gallon range. Richmond consistently tests at the high end of anything we measure in the metro. At these levels a standard 40-gallon water heater can lose meaningful capacity to scale inside a few years, and homeowners usually blame the heater instead of the water feeding it.
How much does a water softener cost in Richmond?
$3,500 installed for the Complete Home System — softening, carbon filtration and tankless reverse osmosis, with installation, programming, pressure test and lifetime warranty included. The dual-tank build is $4,000. Those are the same numbers in Richmond as everywhere else we serve; we do not price by neighborhood.
Why does my Richmond water smell like chemicals?
Richmond runs chloramine on most blended supplies. Chloramine is chlorine bonded with ammonia, so it holds its residual much further into the distribution system and does not air off the way free chlorine does. Carbon removes it, but slowly — which is why a pitcher filter struggles. Whole-home carbon, or a dedicated carbon tank, is what has enough contact time to handle it.
Do you install in Richmond the same week?
Usually. We hold install slots for the Richmond area every week, and most homes are scheduled within a few business days of the water test.
Who performs the installation?
A TCEQ-licensed water treatment specialist or a licensed plumber, as Texas requires for contracted installations. We do not subcontract to unlicensed labor.
Nearby
We also install around Richmond.
Richmond, TX
Find out what is actually in your Richmond water.
Free in-home test, about 20 minutes at your kitchen sink. You get the numbers written down whether or not you buy anything.