Home › Service areas › Montgomery, TX
Water softener & filtration installation in Montgomery, TX
Montgomery sits on the north and west side of Lake Conroe, and unlike Conroe proper it has not gone through the same SJRA surface-water conversion — most of the small MUDs out here are still running straight off Gulf Coast Aquifer wells through Hays Utility North. County testing has also flagged measurably elevated iron alongside the hardness, which shows up as staining well before scale becomes the complaint. Some acreage properties outside the MUD boundaries are on private wells entirely.
typical hardness
Reported range 8–14 gpg · scale 0–20
- Supplier
- City of Montgomery (operated by Hays Utility North) and numerous independent Montgomery County MUDs
- Source
- Gulf Coast Aquifer groundwater, with a few systems blending purchased surface water
- Disinfectant
- Chlorine on most groundwater supplies
- Typical range
- 8–14 gpg
- Classification
- Hard
Figures reflect typical published and field-observed ranges for supplies in this area. Your tap is what matters — we measure it free.
$3,500 Installed
Published price. Not a promo, not only good today.
Installation Included
No separate install fee. No maintenance contract.
Lifetime Warranty
Tanks, valves, housings and major components.
TCEQ-Licensed
Installed by licensed hands, as Texas requires.
The local picture
What Montgomery homeowners actually call us about.
The complaint we hear most often in Montgomery: Orange or rust-colored staining in toilets and sinks, on top of the usual scale.
At 8–14 grains per gallon, every load of laundry, every shower and every cycle through the water heater carries dissolved calcium and magnesium that has to go somewhere. It goes onto your fixtures, into your heat exchanger, and onto your skin.
The supply here is gulf coast aquifer groundwater, with a few systems blending purchased surface water, delivered through city of montgomery (operated by hays utility north) and numerous independent montgomery county muds, with chlorine on most groundwater supplies as the residual disinfectant. That combination determines both how we size the softener and how much carbon the system needs.
- Free in-home test at your kitchen tap — about 20 minutes
- System sized to your measured hardness, not a neighborhood average
- Installed by a TCEQ-licensed specialist or licensed plumber
- Flat price in writing, good for 30 days — no same-day pressure
Neighborhoods we serve in Montgomery
Bentwater, Grand Harbor, Walden on Lake Conroe, Stewart's Point, Historic Downtown Montgomery, Waterstone — plus surrounding Montgomery County communities.
Not listed? We cover the whole Montgomery area and travel up to two hours from our Katy shop. Call (435) 881-7380.
What we usually recommend in Montgomery
The standard build handles Montgomery well.
At 8–14 grains per gallon, Montgomery is firmly in the hard band but not at the extreme end of our range. The Complete Home System at $3,500 — 75 lbs of resin, 15 lbs of coconut shell carbon, 48,000 grain capacity — is sized comfortably for a typical household here.
We would only push you toward the dual-tank build if the house is large, water use is heavy, or your test comes back at the top of the local range. Most Montgomery homes do not need it, and we will say so at the test.
If you are on a private well, none of the above applies until we test. Wells around Montgomery bring iron and sometimes hydrogen sulfide into the picture alongside hardness, and the right system is not the one your neighbor on the MUD bought. Anyone quoting a well without testing it first is guessing.
Recent work
Systems available in Montgomery: Complete Home System, Dual-Tank System, reverse osmosis, pre-sediment and a free water test.
FAQs
Montgomery water questions.
How hard is the water in Montgomery, TX?
Supplies serving Montgomery typically test in the 8–14 grains-per-gallon range. Montgomery sits on the north and west side of Lake Conroe, and unlike Conroe proper it has not gone through the same SJRA surface-water conversion — most of the small MUDs out here are still running straight off Gulf Coast Aquifer wells through Hays Utility North. County testing has also flagged measurably elevated iron alongside the hardness, which shows up as staining well before scale becomes the complaint. Some acreage properties outside the MUD boundaries are on private wells entirely.
How much does a water softener cost in Montgomery?
$3,500 installed for the Complete Home System — softening, carbon filtration and tankless reverse osmosis, with installation, programming, pressure test and lifetime warranty included. The dual-tank build is $4,000. Those are the same numbers in Montgomery as everywhere else we serve; we do not price by neighborhood.
Will a softener help with the sediment in my Montgomery water?
Not on its own. Montgomery draws on groundwater, and sand or grit after main work is a separate problem from hardness. A pre-sediment stage in front of the softener is what catches it, and it protects the equipment behind it.
I am on a private well outside Montgomery. Can you help?
Yes, but the approach is different. Wells bring iron and sometimes hydrogen sulfide into the picture alongside hardness, and the system has to be built around what your specific well is doing. We test first, always. Anyone quoting a well without testing it is guessing.
Who performs the installation?
A TCEQ-licensed water treatment specialist or a licensed plumber, as Texas requires for contracted installations. We do not subcontract to unlicensed labor.
Nearby
We also install around Montgomery.
Montgomery, TX
Find out what is actually in your Montgomery water.
Free in-home test, about 20 minutes at your kitchen sink. You get the numbers written down whether or not you buy anything.